- Joined
- Jun 3, 2003
- Posts
- 547
I have a US TurboDuo that I just did a laser replacement on. The laser was no longer reading CD-R's so I figured it was starting to go. Well the laser appears to be working (it moves on its track and I see the lense move up and down) but the CD won't spin. It's like the spindle isn't getting power or something. There is absolutely no CD movement at all. The laser just moves to the ready position (right next to the spindle) and moves up and down a few times while the CD stays stationary. It then says "Please Set Disc".
The unit was just recapped and was working fine before the laser replacement so that can't be the problem. I also have the CD lid button held down so that's not it (it doesn't say that the lid is open). I tried swapping in the old laser again and the CD still didn't spin so I don't think the laser is the issue either. None of the wires inside look broken either.
I can't see how I could have broken anything, replacing the laser was a snap. Nothing hard about it and it went smoothly. I'm completely stumped on this.
The unit was just recapped and was working fine before the laser replacement so that can't be the problem. I also have the CD lid button held down so that's not it (it doesn't say that the lid is open). I tried swapping in the old laser again and the CD still didn't spin so I don't think the laser is the issue either. None of the wires inside look broken either.
I can't see how I could have broken anything, replacing the laser was a snap. Nothing hard about it and it went smoothly. I'm completely stumped on this.