- Joined
- Jan 5, 2001
- Posts
- 18,070
Curious about this issue. I revived the light on the marquee, redid the cp wiring, restored the cp entirely, including a major reduction of the rust under it. Looks like a drink spill issue gunked it up. I reflowed the power supply, that is working. It's slowly coming together.
Well, I need to figure out this monitor, as it keeps blowing fuses every time I put one in the chassis. I see a sign of some type of burn marks on the psu section of the chassis, it's not so bad, but there is this polyester film capacitor there that looks like its slightly cooked.. Tested the diode's in that section, and they are good and one direction only. I am also wondering if the HOT is a issue here. Should I just replace this? Getting zero glow on the guns. Advice appreciated!
Well, I need to figure out this monitor, as it keeps blowing fuses every time I put one in the chassis. I see a sign of some type of burn marks on the psu section of the chassis, it's not so bad, but there is this polyester film capacitor there that looks like its slightly cooked.. Tested the diode's in that section, and they are good and one direction only. I am also wondering if the HOT is a issue here. Should I just replace this? Getting zero glow on the guns. Advice appreciated!
Last edited: