malignantpoodle
Robert Garcia's Butler
- Joined
- Aug 21, 2010
- Posts
- 1,281
Trying to install a JROK and I'm looking for a clean 5 volt, but can't seem to find an open one.
Any insight would be appreciated.
edit;
To clarify; following the 5 volt and ground from the top of the wiring harness down it goes to a molex which hooks into the power supply (another molex). So straight from the PSU to the board on 5v and ground. How do I tap that to run 5v to the JROK, remove the 5v and ground pins from the wiring harness and go that way? Aren't those used for something else? Splice the wire?
Any insight would be appreciated.
edit;
To clarify; following the 5 volt and ground from the top of the wiring harness down it goes to a molex which hooks into the power supply (another molex). So straight from the PSU to the board on 5v and ground. How do I tap that to run 5v to the JROK, remove the 5v and ground pins from the wiring harness and go that way? Aren't those used for something else? Splice the wire?
Last edited: