MV-1C surface mount bios

I was just finishing up consolizing a 1C board when my ten month old came to see what Dad was up to. Anyway, after a quick tug, one of the filament thin traces was ripped from the board (I hadn't glued them yet).

Will I be able to trace it back to the bottom side of the board and get the signal from there, or is it time to buy a new board?

Any ideas?

Thanks guys.

30 ga kynar wire wrap wire will be what you need to jumper the pulled trace.

It snapped right at the microscopic hole, leading to the bottom of the board.

Should I just pick it up on the other side?

Thanks for the reply.

If you're able to trace it to a better solder point then do it dude.