N00B question about AES modification

ISODee

Armored Scrum Object
Joined
Dec 13, 2007
Posts
266
So I decided that I open my AES and make the led modification. Well I also found @ JammaNationX about fixing the Vertical Lines problem. I have 3-6 board but I´m not so sure making this wihtout couple answers. So I use RBG cable and got those annoying lines and I dont got the skills to make RGB output. :oh_no:

-So if I just cut those lines will the picture quality be same but those lines goes away?
-OR do I have to make somekind video modification before that?
-Will this effect the picture quality if I buy X-Neo1 in future.
- Is there any reason buy X-Neo1 if I get rid of those lines
-And do I have to cut the traces at both sides of the board?

Hopelly I get answers quick. I´m making the led modification tonight and mayby this line modification at as well

http://www.jamma-nation-x.com/jammax/tutorials.html#aesvideolines
 

Xian Xi

JammaNationX,
15 Year Member
Joined
Dec 1, 2005
Posts
27,748
Yes. Picture quality is the same but the lines will be gone.

It's best to remove the trace entirely but if you can't then cut it on both sides of the trace as shown in the tutorial.
 

ISODee

Armored Scrum Object
Joined
Dec 13, 2007
Posts
266
I was just bout to ask what I should cut at front???
Will try it.. Hopelly I dont broke anything.
 
Last edited:

ISODee

Armored Scrum Object
Joined
Dec 13, 2007
Posts
266
Nothing anymore. Problem was that didnt open the screws @ cartslot :P
 
Last edited:

Xian Xi

JammaNationX,
15 Year Member
Joined
Dec 1, 2005
Posts
27,748
Tilt the board from the back about 45 degrees then pull it towards the back to take it out. It's not the controller ports but there is a retaining post that holds the board in.
 

ISODee

Armored Scrum Object
Joined
Dec 13, 2007
Posts
266
1st try still got the lines. 2nd try --> going to cut deeper --> Fail goddamn -> 3rd try FFS

WOOOW I DID IT!!! 4try THANKS!!! now the led mod -->
 
Last edited:
Top