Jrok v4 board RGB pass through

Does anyone know if the pass through on the Jrok v4 board is same as the signal going in or is it split or amplified some how? Long story short i want to run both the jrok board and the use the rgbs output signal on 2 different monitors. I'm wondering if i need to build a amp to split the signal before the board or if I can just use the output as is or a amp after the board to get a better signal.

You need an amp. The pass through is only if you make an on/off switch for your encoder.

Oh well so much for hopeing. Any suggestions on a amp that would be reasonable to build for this? I know there are a few out there but I haven't messed with any so any suggestions would be great.

Are you sure an amp is necessary?

Simply terminating both ends of each output with a 75 ohm load could quite possibly be adequate.

It's not needed but when running dual monitors the picture is a bit dark. I think it depends on what PCB you use really.

Hmm fair enough.. Should be able to make an amp with 3 BC548's for about $1.