MV-1FS speaker and headphone connector?

D

doctor_shred

Zero's Secretary
Joined
Apr 15, 2008
Posts
154
Hi,

Does anyone know what type of connector fits the two 4-pin points on the MV-1FS?

I'm starting to consolise one and want to use these for audio output rather than soldering to the base of the board. Thanks.
 
Xian Xi

Xian Xi

JammaNationX,
15 Year Member
Joined
Dec 1, 2005
Posts
27,750
If you are consolizing you only need +5v so just need the headphone connector. It should be a standard 4 pin. Maybe something like a 1.58 pitch?
 
D

doctor_shred

Zero's Secretary
Joined
Apr 15, 2008
Posts
154
Thanks Xian Xi. I'm using the guide on your site for the project - it's a fantastic resource :)

Is that the same as a floppy disk drive power connector?
 
D

doctor_shred

Zero's Secretary
Joined
Apr 15, 2008
Posts
154
Great, thanks. I'll look into getting one of those or something similar.

I tried a floppy drive power connector, the pin spacing is fine but the holes in the connector are too small for pins on the MVS. Shame...
 
norton9478

norton9478

So Many Posts
No Time
For Games.
20 Year Member
Joined
Oct 30, 2003
Posts
34,074
It's the one that goes on a floppy drive power connector.
 
D

doctor_shred

Zero's Secretary
Joined
Apr 15, 2008
Posts
154
Thanks for those links MKL.

It does look like a 4-pin floppy drive power connector but the one I had lying around doesn't fit. I'll pick one up and see if that's different.

Cheers.
 
You must log in or register to reply here.
Top