I bought some parts off a guy from ebay and finally got them today.
I bought a 4 slot,2 credit boards w/ cables, Memory card reader w/ cables, both el panels with 1 cable to connect the 2 but not the cable to connect it to the 4 slot and the speaker wood panel that goes behind the light panels.
Everything is fithly ofcourse.. i spent an hour cleaning up the memory card reader and then i looked at the pins in the card slot.. At first i checked it ealier and thought there was some junk in there but nope.. it was 2 bent over pins next to eachother.
Thought theres a chance i could straighten them out but figured they would break.. Yup. Pretty much right when they straightened out there weak and about to snap off.
The board looks like it was from the junk yard.. but the seller told me it was from the 4 slot they were going to fix up but insted they gutted it cause theres no money in arcade games anymore.
So anyways.. anyone know of a pinout for the memory card reader?? Thinking i could replace the pins with something and solder then on and try it out.
Also.. I need a pinout for the power board that goes between the light panels to the 4 slot. I dont have cables for either end. Figure the light panels will be bad but want to check them anyways.
Now to quickly clean the 4 slot and try it and see if i get lucky and its good.
I bought a 4 slot,2 credit boards w/ cables, Memory card reader w/ cables, both el panels with 1 cable to connect the 2 but not the cable to connect it to the 4 slot and the speaker wood panel that goes behind the light panels.
Everything is fithly ofcourse.. i spent an hour cleaning up the memory card reader and then i looked at the pins in the card slot.. At first i checked it ealier and thought there was some junk in there but nope.. it was 2 bent over pins next to eachother.
Thought theres a chance i could straighten them out but figured they would break.. Yup. Pretty much right when they straightened out there weak and about to snap off.
The board looks like it was from the junk yard.. but the seller told me it was from the 4 slot they were going to fix up but insted they gutted it cause theres no money in arcade games anymore.
So anyways.. anyone know of a pinout for the memory card reader?? Thinking i could replace the pins with something and solder then on and try it out.
Also.. I need a pinout for the power board that goes between the light panels to the 4 slot. I dont have cables for either end. Figure the light panels will be bad but want to check them anyways.
Now to quickly clean the 4 slot and try it and see if i get lucky and its good.
