PDA

View Full Version : CPS1 to CPS2 kick harness adapter?



BeaglePuss
04-13-2008, 02:55 PM
I've read that Cyberleads are prewired for both CPS1 and CPS2 (link: http://www.cyberlead.co.uk/cyberlead/cyberlead.htm ), but I can't seem to find the CPS2 kick harness on my cab. I've found the CPS1 kick harness though. I was wondering if anyone here has used a CPS1 to CPS2 kick harness adapter? They're very inexpensive, so I figured I'd give them a shot. Are they reliable?

They look as though they just pop in/pop out without the use of solder. Does that make sense?

So basically I'm seeing if anyone would recommend not purchasing an adapter, or if anyone knows if Cyberleads are prewired for CPS2?

I plan on using exclusively CPS2 my Cyberlead, so if there's an easy permanent solution, I'm all ears.

AMurderofCrows
01-26-2016, 09:46 AM
resurrecting this dead thread as i have the exact same question

Westcb
01-26-2016, 09:57 AM
resurrecting this dead thread as i have the exact same question


If you need a cps1 to cps2 adapter or vice versa you can buy one from xianxi.

Razoola
01-26-2016, 11:45 AM
This needs moving to the general tech support forum.

Rot
01-26-2016, 12:06 PM
This needs moving to the general tech support forum.

...Dumb fookin n00bs....

Xian Xi
01-28-2016, 01:47 PM
If you need a cps1 to cps2 adapter or vice versa you can buy one from xianxi.

They'll be back in stock later today. I need to cut them.

AMurderofCrows
03-30-2016, 02:38 AM
They'll be back in stock later today. I need to cut them.

I didn't get a notification for this.

Xian, i'm in need of Cyberlead CPS1/2 kick harnesses, if you have them.

Xian Xi
03-30-2016, 04:02 AM
I didn't get a notification for this.

Xian, i'm in need of Cyberlead CPS1/2 kick harnesses, if you have them.

The CPSX adapters are in stock on my site, just choose which one you need, either CPS2 to CPS1(CPS2 harness on CPS1 PCB) or CPS1 to CPS2(CPS1 harness on CPS2 PCB).

AMurderofCrows
03-30-2016, 10:34 AM
The CPSX adapters are in stock on my site, just choose which one you need, either CPS2 to CPS1(CPS2 harness on CPS1 PCB) or CPS1 to CPS2(CPS1 harness on CPS2 PCB).

Do you happen to make a harness/adapter that goes to the 10 pin "berg" layout on a Cyberlead's JV Conn board?

Xian Xi
03-31-2016, 07:06 AM
Do you happen to make a harness/adapter that goes to the 10 pin "berg" layout on a Cyberlead's JV Conn board?

I can if you provide the pinout and connector type needed.

ebinsugewa
03-31-2016, 10:41 PM
Got one of these from XX. Buy this man's stuff.