question about atomiswave UPDATED

new question in post 3.

Those wires are part of the JAMMA spec but rarely used. They are for a non amplified mono output and not for driving speakers but rather to be run to an external amp if the onboard amp should fail or if there isnt one provided on the board. Although most boards without audio amps use a separate connector still and dont use these pins anyway from my experience. I have only seen them implimented on a very small amount of boards and never used them once.

since my sega versus cab was set up to run a naomi board, can anyone think of anything off the top of their head that might need to be modified voltage wise or anything at all that would prevent the atomiswave from just being plug and play right off the bat?
should i be good to go to just throw it in and power it on?

anybody know the answer to this?

is the versus city set up for jamma or JVS?

you'll have to wire up buttons 4/5 to the jamma harness for AW.

its already wired up jamma i believe with the 4th buttons wired. wiring the 5th button is no prob. other than that nothing else will be an issue?

shouldn't be any that i can see besides absolutely rocking out to the FOTN intro.