Modding a Hori tekken stick

Gday,





i have this hori tekken arcade stick and i was wanting to swap out the buttons and the stick as recently they have started playing up getting jambed and not registering consistently. Only problem its a bit smaller than the HRAP version, just wondering if anyone has experience with any semitsu/sanwa parts that would fit in this mini stick. I have other sticks but the smallness of this one makes it good to take round to mates places.

what kind of space do you need to fit snap in buttons?
anyone got a link to sanwa/semitsu button and stick dimensions?
cheers

anyone?

matt009au said:

what kind of space do you need to fit snap in buttons?
anyone got a link to sanwa/semitsu button and stick dimensions?
cheers

Click to expand...

Sanwa Snap-in buttons should work fine. I never modded that stick, but excluding the HRAP, Hori sticks use the same button measurements. As far as sticks, I suggest you use a Seimitsu Stick. The Sanwa sticks are a good fit, but the stick shaft sits up higher than a Seimitsu stick. Both sticks will require some modding on your part. A Dremel is a great tool to have for stick modding.

Regarding measurements, you can find them online with a little searching.

Also check out shoryuken.com. There are tons of stick modders over at that site.

cheers mate, yeh i'm a bit of a noob when it comes to modding sticks, just wasn't sure if snap ins would fit as its quite a bit thinner than a hrap.