What knobs are on the BACK of a candy monitor?

I know the knobs on the front, but I have to ask if there usually are more on the back. The reason I ask is my picture on my new cab is freaking great, but it's still a bit too bright... the whites are a little too much... almost bleeding the picture a hair. If I adjust the contrast, it just gets dingy looking... so I know there must be an intensity knob of some sort on the back that I need to turn down? It's a small complaint, and the pic usually looks amazing, but when I die in KOF 98, the white's a little too white...

Do not play with the RGB gain/bias pots on the CRT base pcb, you will never return.

You may however back the screen volts off a little, thats the adjustment below the focus pot on the lfbt.

ttooddddyy said:

Do not play with the RGB gain/bias pots on the CRT base pcb, you will never return.

You may however back the screen volts off a little, thats the adjustment below the focus pot on the lfbt.

Click to expand...

in lamens terms, that black block on the chasis with the big red wire sticking out of it . the voltage pot will usually be glued for factory settings. don't be afraid to break the seal

SamuraiShodownSensei said:

don't be afraid to break the seal

Click to expand...

But if you do, grab a little of your girlfriend's nail polish and put a dab on it when finished. If you don't then the heating/cooling cycles of running the monitor & turning it off will cause the control to ever so slightly turn.

RJ