neobitz wiring help

Well, I have a bit of a problem with knowledge on how to hook up the neobitz video encoder. I have thebig one with composite, componate, and s-video. I recieved a paper saying wich wire is supposed wich, but I'm not sure where the wires go, such as "luma, chroma, (etc.)". Any help will be greatly appreciated!

-idosk8

For the C and Y lines this is what I remember, if you get a dark picture just switch the C and Y lines.


___C----o--o-----Y___
GND--o---------o--GND

This is viewing from the solder side of the jack.


For the Component out the in jack color Y=Green, Pr=Red, Pb-Blue. So basically the outputs go to the center pin of the jack and the outside ring is ground.

Same as above with composite except it's yellow.

thanks man, Ill be able to show off my consolized mv-ic soon.

-idosk8

idosk8 said:

thanks man, Ill be able to show off my consolized mv-ic soon.

-idosk8

Click to expand...

one not i, the MViC is a memory card reader, the 1C is the MVS board. I dont know why SNK named them so similar. But I know what you meant...lol