- Joined
- Dec 1, 2005
- Posts
- 27,762
I just finished building my CMVS about 4-5 months ago and today was the first time I tried to play my MOTW on it.
When it starts I noticed it says level 2 on the bottom of the screen, others it says 4. So when I try to play I noticed that the buttons are all mixed up AC are kicks and BD are punch BUT both sets are of the weak punch and kick, no strong punch or kick. Also I notice that once the match starts it says "Final Round" and the timer is set at 10 seconds.
So I do a soft reboot and set it as console euro to see if I can config the buttons, it wont let me, I tried all regions and settings and same thing. As soon as the screen comes up Light punch has A and Strong Kick has B and the 2 in between are blank and I can't change anything, it kinda freezes.
So then I do another soft reboot and do a CRC check, ROM Region was OK and ROM Bank 0-3 came up as "custom"
Now is this due to the fact that I am using a MV1C board that in order for it to boot I had to connect pins 39 and 40? Also am I supposed to leave 39 and 40 connected at all times or was it just for the very first initial boot of the board?
I know my cart isn't a boot as I used to play it on my AES via the blue P1 and it worked perfectly and both my AES and CMVS have UB 2.2 installed.
Here are some pics:
When it starts I noticed it says level 2 on the bottom of the screen, others it says 4. So when I try to play I noticed that the buttons are all mixed up AC are kicks and BD are punch BUT both sets are of the weak punch and kick, no strong punch or kick. Also I notice that once the match starts it says "Final Round" and the timer is set at 10 seconds.
So I do a soft reboot and set it as console euro to see if I can config the buttons, it wont let me, I tried all regions and settings and same thing. As soon as the screen comes up Light punch has A and Strong Kick has B and the 2 in between are blank and I can't change anything, it kinda freezes.
So then I do another soft reboot and do a CRC check, ROM Region was OK and ROM Bank 0-3 came up as "custom"
Now is this due to the fact that I am using a MV1C board that in order for it to boot I had to connect pins 39 and 40? Also am I supposed to leave 39 and 40 connected at all times or was it just for the very first initial boot of the board?
I know my cart isn't a boot as I used to play it on my AES via the blue P1 and it worked perfectly and both my AES and CMVS have UB 2.2 installed.
Here are some pics:

That sounds funny. 
last time I saw it was searching for some Sam sho crt check/info.

