mvs 6 slot problem

arcadeblazer · Apr 30, 2006

HI THERE,I SEEM TO BE HAVING SOME PROBLEMS GETTING MY NEW MVS 6 SLOT BOARD TO WORK IN MY LEISURE 2000 CAB.I HAVE A 1 SLOT BOARD AND I ALSO RUN A TAITO F3 BOARD THROUGH A JAMMA SPLITTER AND THESE WORK FINE.I JUST CANNOT SET THIS UP.GOT ANY TIPS I MAY HAVE MISSED.

topher · Apr 30, 2006

FIRST TIP... STOP YELLING

there is no reason to use all caps...

it's hard on the eyes, I couldn't even read your question because of it...

SpamYouToDeath · Apr 30, 2006

Please speak English.

channelmaniac · Apr 30, 2006

Can ya tell us a little more about what the "problems" are? We need a better description before we can offer up help.

mIRC said:
* channelmaniac slaps arcadeblazer with a large trout

AppleiDog · May 1, 2006

Are you sure there is enough power running though your 6 slot?

ttooddddyy · May 1, 2006

The 6 slots draw around 5 amps from the 5 volt rail. (the other boards you have draw less)
So as appleidog suggested, best start there.
measure the 5 volts at the board set, not the power supply as there will be voltage dropped in the harness.
If this is the issue the board will not get passed the initial preboot stage where you see the green screen with some jumbled gfx.

neotopia · May 17, 2006

I've had similar predicument with my 6-slot MB. I did some scrubbing on the the jamma connector and it works great now. I hope yours will do the same

mvs 6 slot problem

arcadeblazer

Guest

topher

Tesse's Maintainence Man

SpamYouToDeath

I asked for a, Custom Rank and, Learned My Lesson.

channelmaniac

Mr Neo Fix-it

AppleiDog

Shamrock Chatster

ttooddddyy

PNG FTW,

neotopia

n00b