cps2 kick harness question

thchardcore · Dec 24, 2005

Hi, I bought a kick harness recently and the POS isnt polarized so I have no idea how it snaps in. I'm plugging into a blue A board and I was wondering if the 2 grounds (1p, 2p) should be on the right (I think this is it) or on the left.

Anyone have a picture showing the pinout?

I looked high and low and found nothing that showed me where pins 1-34 actually were located.

Thanks

300wins · Dec 24, 2005

thchardcore said:
Hi, I bought a kick harness recently and the POS isnt polarized so I have no idea how it snaps in. I'm plugging into a blue A board and I was wondering if the 2 grounds (1p, 2p) should be on the right (I think this is it) or on the left.

Anyone have a picture showing the pinout?

I looked high and low and found nothing that showed me where pins 1-34 actually were located.

Thanks

http://www.system16.com/jamma.php

Basically, the 2 ground pins should be on the RIGHT.
Scroll down to the bottom. Hope that helps.

Lime2K · Dec 24, 2005

If you look really carefully on the connector there should be numbers on the top and bottom.

That's assuming that it is an official capcom part (or you're using the correct replacement connector -- www.digikey.com has it, it's part H3828-ND)

I have some extra, but I dunno where they are right now, so I can't check.

Lime2K

cps2 kick harness question

thchardcore

Another Striker

300wins

Conan The Librarian,

Lime2K

Host for Orochi