RamonG
World Soccer '96
- Joined
- Jun 12, 2004
- Posts
- 122
Whats up guys? Here I am asking for help again.
I searched the tech forum for any sound problems for the Atomiswave, I could not find anything that would help.
Anyways here is my Atomiswave adventure so far:
I just bought an Atomiswave with KOF Neowave and I plugged into one of my machines where I had a 1-slot board. The machine is an older one converted to a MVS, it has williams serial number.
Well, the game booted up fine, the screen looked like crap, it seemed too bright, with washed up colors, after adjusting time after time, I finally made it look OK(not great, I still need to keep adjusting). Now for the sound: I haven't been able to get any sound, I'm trying to get it off the mono on the Jamma plug, on the instructions of the Atomiswave, it specifies the mono sound comes out of Pin 10 mono speaker (+) and Pin L mono speaker (-).
I followed the cable from those pins, it leads into the speakers, but it was not connected, I guess because on the 1-slot you do not need it. So I plugged this cable to one speaker, but no sound comes out, I already went into the settings and configured the Atomiswave for mono sound, checked the volume control, but still no sound.
Any help or suggestions are appreciated.
Thank you all.
I searched the tech forum for any sound problems for the Atomiswave, I could not find anything that would help.
Anyways here is my Atomiswave adventure so far:
I just bought an Atomiswave with KOF Neowave and I plugged into one of my machines where I had a 1-slot board. The machine is an older one converted to a MVS, it has williams serial number.
Well, the game booted up fine, the screen looked like crap, it seemed too bright, with washed up colors, after adjusting time after time, I finally made it look OK(not great, I still need to keep adjusting). Now for the sound: I haven't been able to get any sound, I'm trying to get it off the mono on the Jamma plug, on the instructions of the Atomiswave, it specifies the mono sound comes out of Pin 10 mono speaker (+) and Pin L mono speaker (-).
I followed the cable from those pins, it leads into the speakers, but it was not connected, I guess because on the 1-slot you do not need it. So I plugged this cable to one speaker, but no sound comes out, I already went into the settings and configured the Atomiswave for mono sound, checked the volume control, but still no sound.
Any help or suggestions are appreciated.
Thank you all.