Cab On-Off Switch Installation Tutorial Needed..

I want to install an On & Off switch in a cab(Klax/Conversion) and I'm not sure where to put it in-between,the wiring etc..

Link/Help Please..Thanks..

The Cab has an original (2 Wire)switch in the back(hidden) that I just can't get to/mess with and for some reason it only turns off the monitor....I'm totally leaving that alone ..

I have a switch and it's wires.(the same type in the Big Red/Neo Gold and Tekken 3).
It has 4 Wires..
1 Yellow
1 Yellow/Black
1 Red
1 Red/Black
It seems if I click it to one side/on.. the Yellow & Yellow/Black create a full current and the Red & Red/Black create a full current..otherwise if switch is off I get no continuity between any of them..
4 Wires,why do I need 4 Wires..?

What do I put this in-between./ put in between the two AC in wires going to the Jamma Power Supply.

..........................................................................................................
If I need a switch what should I look for/prefabably something I can buy in a store.

This might help you.

http://www.hardmvs.com/html/powerBoard.htm

Be carefull of not touching the prongs though... you get a little electrocuted if you do (talking from personal experience) about the only fun part about it is the after adrennaline fix... I'd suggest using tape of something... that's what I did... but I don't have anything solid to mount the switch to yet.

Flavor said:

This might help you.

http://www.hardmvs.com/html/powerBoard.htm

Click to expand...

Thank you so Much..I forgot all about that info there and it helped me a lot today..

stuffmonger said:

Be carefull of not touching the prongs though... you get a little electrocuted if you do (talking from personal experience) about the only fun part about it is the after adrennaline fix...

I'd suggest using tape of something... that's what I did... but I don't have anything solid to mount the switch to yet.

Click to expand...

Thank you..

Be carefull of not touching the prongs though...

Click to expand...

Ohhhh Yeaaa,I was scared to touch those prongs today as I would of got a nice shock..

I don't have anything solid to mount the switch to yet

Click to expand...

I didn't either..I get it all in and realize I don't have anything solid to mount the switch to.
So I looked through my boxes or Arcade parts and found a plate that the switch fit right on./sweet!!..

Success.. .I put the on-off switch in the KLAX and it's right behind the coin door on a plate/on the right....
The Multimeter helped big time too