Conversion from 1 slot to 4, do I have this right

1) print out the 1 slot and 4 slot manuals, note the differences in the jamma pins.

2) disconnect the jamma connector from the 1 slot board.

3) mount the 4 slot board, reconnect the jamma based on the different config

4) Test

5) wire the game select button etc

6) invite over 2 strippers and a case of beer and give that cab a workout

Am I correct in this? How am I libel to destroy my new baby?

Thanks.

FrostbayneAucti said:

1) print out the 1 slot and 4 slot manuals, note the differences in the jamma pins.

2) disconnect the jamma connector from the 1 slot board.

3) mount the 4 slot board, reconnect the jamma based on the different config

4) Test

5) wire the game select button etc

6) invite over 2 strippers and a case of beer and give that cab a workout

Am I correct in this? How am I libel to destroy my new baby?

Thanks.

Click to expand...

..

Well..
Lets see:..Let me change it around.

1) print out the 1 slot and 4 slot manuals, note the differences in the jamma pins.

2) disconnect the jamma connector from the 1 slot board.

3) Based on the different config of a 4 Slot,depending on just what you are doing.. Are you adding a second Speaker or is the current set-up use two Speakers..(?)
As some 1 slots have a switch for Mono and Stereo..
..Wire that all up first,plus wire the game select button in etc..

4)mount the 4 slot board

5) Test

6) invite over 2 strippers and a case of beer and give that cab a workout

7)Get the Strippers to Ride the Joysticks to give them a good whirl/testing..

It's mono I believe.

And the strippers better not have mono...

personally, I would mount the strippers before the 4-slot!