MV-1 Stereo Output question

How do you get stereo output from an MV-1 Board?

Says "stereo output through PCB connector - YES" at Hardmvs.

whats the PCB connector and how do i rig it up? Since it does not get stereo through the harness, me wants left and right.

So i guess this is a stupid question that I could figure out on my own?

There is a 4 pin connector for headphones that's CN1. It's something like right, ground, ground, left (maybe left, ground, ground, right? i know the grounds are in the middle). Same size as pc speaker connector, power supply connector for some 3.5" disk drives, and sound output (to soundcard) on really really old cd-rom drives. It will work w/ headphones or drive the input to a tv/stereo system, but probably won't drive any real speakers because of the way it is amplified.

CN2 is amplified stereo output suitable for driving speakers. There's a stereo/monaural switch on the board somewhere.

If you are going to use this with your tv and a supergun you should use CN1 because using CN2 could damage your TV and/or your MVS.

Some of this is in the manual at hardmvs http://www.hardmvs.com/manuals/MV-1 Partial.pdf

cheers,
-DT

as dogtoy said, beware the level, its not line output