Crossed Swords Scaling Issue

Hello everyone,

Yesterday I became the proud owner of the very own AES system Cost me quite a bit but I have to say it's worth every penny.

I've just spent the last hour or so reading through these forums learning as much as i can about my new purchase. I noticed that on my Crossed Swords cart there seems to be slight glitching on the enemy sprites if they are scaled out, once they jump in front of you they look fine.

I've seen a number of posts here that refer to scaling glitches being an issue on converted MVS boards with newer machines. I was hoping someone could help shed some light on whether this is the case with my cart or not.

My console is Japanese, serial number is in the region of 230000. I'm willing to take the case of if there's any identifiable markings that would help. The same goes for the cart if there's anything to look out for there.

For what it's worth I also have a Fatal Fury cart and it runs perfectly.

Thanks for you time.

RealaT

lord

You have an aes so every game should run perfectly....
Give the cart contacts a clean....

give the cart contacts a clean and try pulling back the cart a few millimeters when inserted.

Normally scaling problems are generated my bad contact between the cart pins and the system slot.

Cheers for the tips guys, i'll try giving the contacts a clean when i get in from work this evening.

I already tried pulling the cart out about a millimetre or so, but then I had scaling problems and no sound either!!