Irritating Maze Dedicated Bulbs

Can someone with an Irritating Maze (dedicated cabinet) manual tell me what are the correct bulbs to use in the marquee area?

There are 4 sockets:

Fluorescent fixture that is 26" wide
Two screw-in's for red bulbs (I need to know wattage)
a small screw in that is literally part of the flourescent fixture that is wired parallel to the flourescent.

I could really use the specs on these four fixtures. I am very close to restoring this cab to 100% original. It is definately one of the best in my gameroom.

Danny Clark

skylighter said:

Can someone with an Irritating Maze (dedicated cabinet) manual tell me what are the correct bulbs to use in the marquee area?

There are 4 sockets:

Fluorescent fixture that is 26" wide
Two screw-in's for red bulbs (I need to know wattage)
a small screw in that is literally part of the flourescent fixture that is wired parallel to the flourescent.

I could really use the specs on these four fixtures. I am very close to restoring this cab to 100% original. It is definately one of the best in my gameroom.

Danny Clark

Click to expand...

Try getting in contact with Bob Roberts...I think he sells the bulbs you need and may provide you the info you need.



http://www.therealbobroberts.com/

Answer to light bulb question

Very rarely in this hobby do you get a GOOD surprise. Today I got two. The first was that I found the manual in the coin drawer, which was locked up till now.

When I read the manual, I found out that my pump has a shipping strap on it and that is why it was so freaking loud. This is good because a new pump retails for $400.

I am posting the answer to my own question in case someone comes looking for the info later:

Lights in the Irritating Maze Dedicated:

Fluorescent: 360mm 30watt T10 (FL30SW)
Ballast: FG1E (screw's into socket in back of fixture)
Screw-Ins behind marquee: Red 40w floods (R62-R-110v-40w)
Timer Lights: T10WB; 24V, 4.5W (same as used in Pachislo slot machines)
Under trackball: T19E12; 24V, 5W
Behind Bezel L/R Upper: Flash Lamp (OS90SA-E26C) (aka strobe bulbs)
Behind Bezel L/R Lower: Regular bulb 40w (A550-SW 40w)
Behind Bezel Bottom : Flash Lamp (OS90SA-E26C) (aka strobe bulbs)

If your flash bulbs arent working, you may need to replace the relay:
Model: Omron G2R-1A-T (available at Grainger)

Air compressor is a Medo 0610 110v

Hope this helps someone in the future.

Danny Clark

I should have also mentioned that the fluorescent bulb which is a
F30T10 is almost impossible to find. I replaced the whole fixture. If you are really dying to have this exact bulb, I "beleive" that the GE bright-stick light available at Walmart uses this bulb.

Thanks,
Danny