Casing for Consolization of MVS (MV-1F)?

'ello all,

I've been messing around with my MV-1F and Supergun... and I'm starting to think that it might be fun to consolize the system. If I do consolize it though, I definetly want a nice case like you see on the 2-slot systems.

This is my MVS.

As you can see, the carts load horizontally... so I'm thinking about making a kind of hood on hinges that could be lifted whenever you want to switch games and then re-latched down.

I was hoping someone else who's done this could throw me a couple of hints. Did you use an alluminum case? Would that be hard to make? Wood?

Any suggestions or ideas on how it could be done would be much appreciated,

Thanks!

If you want it completely enclosed in a metal box, you can use a small empty breaker panel box.